Post by lmarklar on Jun 23, 2011 17:15:36 GMT -7
I had to sell my project car so now I have a bunch of parts around that I can sell (probably to finance my next project that never gets done 
)
All parts are in Grand Junction Colorado.
- T56 out of 04 Cobra 46xxx miles $1200
-Input shaft is lightly twisted, I have a brand new 26 spline shaft to go with
it.
- TB retaining sleeve is marred up so I have a brand new sleeve also
- 351W roller block complete motor EFI(minus ecm) from bronco? Also will throw in 5.0 cam/rockers/retainer $650
I think it was 69xxx miles, never asked since I was planning to tear down and bore .030 over anyway.
- 408 stroker kit, brand new in box, probe pistons, scat crank, HB, flywheel, balanced. $1400 (this is going off memory, if you send me a message I will pull the paperwork and give you the full specifics instead of my crappy memory) sale pending
- Set of Bare Dart Pro1 195cc as cast heads - $500 SOLD
- Trick flow type R 90mm intake w/90mm maf - 550
- 9" pumpkin, 3.73 gears, eaton worm gear locker, brand new never installed, aluminum housing. If anyone's interested I will get more specifics and splines and whatnot off it.
I also have some Ron Morris mounts for the motor and transmission to put them into a early model mustang without cutting.... or so they say....
(think earlier than 66 or so you might have to cut anyway) if interested let me know and I'll shoot you a price for the set or whichever you need.
and a complete set of floor pans for a 67-68 stang coupe.
)All parts are in Grand Junction Colorado.
- T56 out of 04 Cobra 46xxx miles $1200
-Input shaft is lightly twisted, I have a brand new 26 spline shaft to go with
it.
- TB retaining sleeve is marred up so I have a brand new sleeve also
- 351W roller block complete motor EFI(minus ecm) from bronco? Also will throw in 5.0 cam/rockers/retainer $650
I think it was 69xxx miles, never asked since I was planning to tear down and bore .030 over anyway.
- 408 stroker kit, brand new in box, probe pistons, scat crank, HB, flywheel, balanced. $1400 (this is going off memory, if you send me a message I will pull the paperwork and give you the full specifics instead of my crappy memory) sale pending
- Set of Bare Dart Pro1 195cc as cast heads - $500 SOLD
- Trick flow type R 90mm intake w/90mm maf - 550
- 9" pumpkin, 3.73 gears, eaton worm gear locker, brand new never installed, aluminum housing. If anyone's interested I will get more specifics and splines and whatnot off it.
I also have some Ron Morris mounts for the motor and transmission to put them into a early model mustang without cutting.... or so they say....
(think earlier than 66 or so you might have to cut anyway) if interested let me know and I'll shoot you a price for the set or whichever you need.and a complete set of floor pans for a 67-68 stang coupe.